Model Train Trolley Reversing Unit for HO and N scales or any DC trolley

Description: MODEL TRAIN TROLLEY REVERSING UNIT FOR HO AND N SCALES OR ANY DC TROLLEY We are pleased to offer a very simple and reliable model train trolley reversing circuit. If your layout has a trolley or streetcar, you can use this circuit to control the movement of the trolley. It is assumed the track is not continuous. The trolley will start at one end of the track and run along until it comes to the other end of the track. It will stop and wait for a few seconds and then reverse and go to the other end of the track, where it will stop and wait. The wait times and the speed can be adjusted. There is also an input to stop the trolley during its travel. The unit is pictured showing the two adjustable pots for speed and time on top. The power goes in on one side and the track voltage (red & black wires) comes out on the opposite side. There are two additional wires: Blue and Green that need to be connected as shown in the diagram. The Blue and Green wires allow you to connect the Trolley Reversing Circuit (TRC) to the track without having to solder the diodes. However if your trolley runs a distance you might find that installing the diodes is actually easier. Both methods are described in detail in the manual and below. The package includes: a 16-volt power supply, reversing circuit and two adjustment pots for speed and time. Two diodes and plastic rail joiners are included. The reversing circuit is all solid-state and has no moving parts. There are also no relays to malfunction. You adjust the speed by turning the speed adjustment knob. The speed uses PWM control, which is the latest and best way to control the speed of a model train motor. The time adjustment knob allows you to have a pause at the end of the trolley travel. Your trolley travels along a track and will stop at both ends of the track. The time adjustment will allow you to vary the time, that the trolley will wait before it reverses direction. There is an additional input for a switch or a sensor that allows you to stop the trolley at any point along the trolley track. This could simulate a stop to pick up or discharge passengers. Detailed instructions and parts are provided for you to do this. The diagram shows the wiring connections that need to be made. Also included are the two insulated rail joiners for HO and also N scale. This circuit will work with HO and N scale trolleys and streetcars. It will work with any type of HO and N scale train track.HO USERSWe have included four metal HO track joiners with colored, soldered wires attached. The wires are 6" long and are meant to be spliced to the controller wires. No soldering required. This should help in attaching wires to your HO track. COSTSThe cost of our trolley reversing circuit is $99. Shipping is $12. NOTE - This circuit will not work with a DCC trolley. It is meant for a DC powered trolley. However some Bachmann Spectrum Trolleys have dual mode DCC decoders. This type of decoder detects whether you have a DC or DCC track. One customer had a dual mode trolley and reported that the circuit worked for his trolley. Please allow two weeks for delivery.

Price: 99 USD

Location: Kingston, Pennsylvania

End Time: 2024-07-18T18:52:43.000Z

Shipping Cost: 12 USD